TYPICAL SENSOR TAP INSTALLATION LAYOUT

Sensor Tap Installation


Sensor Tap Installation

The installation of Autotaps electronic taps is quite straightforward and easy to implement, especially if you’re running the system off battery-power option. It’s important that you have adequate water-supply pressure, and your system is properly flushed relieving of any trapped air or dirt.

In most cases, the tap supplied/bought will be a single-supply type (as shown below), and care must be given to adequate and safe water temperature to end-users. A thermostatic mixer valve will be required to regulate/mix hot and cold water to a safe temperature.

If your water is already mixed, or you’re feeding/supplying the control box with only cold water supply, then a thermostat or a blending valve will not be necessary.

Steps 1-3

Installation Steps 1-3

Steps 1-3

Sensor tap Installation Process
01

Unboxing

Remove Sensor tap from its packaging
02

Flexible Hose

Connect the flexible hose to the base or bottom
03

Sink

Feed the flexible hose through the sink hole

Steps 4-6

Installation Steps 1-3

Steps 4-6

Fixing sensor tap to the sink and removing battery cover
04

Fittings

Attach fittings to the base of the tap and securely fasten
05

Battery

Open the battery compartment
06

Battery box

Take out the battery box

Steps 7-9

Installation Steps 7-9

Steps 7-9

Installation of batteries and fixing control box to the wall.
07

Battery Box

Open the battery box
08

Batteries

Insert 4x AA alkaline batteries of the same brand
09

Control Box

Securely attach the control box to the wall

Steps 10-12

Installation Steps 10-12

Steps 10-12

Installation of water supplies and connecting sensor cable.
10

Water OUTLET

Connect flexible hose from the tap to the 'Outlet' point of control box
11

Water INLET

Connect cold/pre-mix water supply to the 'inlet' point of the control box
12

Sensor Cable

Connect the sensor cable from tap to the control box. Test and finish