
Sensor Tap Installation
In most cases, the tap supplied/bought will be a single-supply type (as shown below), and care must be given to adequate and safe water temperature to end-users. A thermostatic mixer valve will be required to regulate/mix hot and cold water to a safe temperature.
If your water is already mixed, or you’re feeding/supplying the control box with only cold water supply, then a thermostat or a blending valve will not be necessary.
Steps 1-3

Unboxing
Remove Sensor tap from its packagingFlexible Hose
Connect the flexible hose to the base or bottomSink
Feed the flexible hose through the sink holeSteps 4-6

Fittings
Attach fittings to the base of the tap and securely fastenBattery
Open the battery compartmentBattery box
Take out the battery boxSteps 7-9

Battery Box
Open the battery boxBatteries
Insert 4x AA alkaline batteries of the same brandControl Box
Securely attach the control box to the wallSteps 10-12
